Copper Harbor Cemetery

Due to the age of the cemetery and the ornate headstones, Copper Harbor Cemetery is a popular place for those interested in tombstone rubbings.

Tombstone rubbings are commonly used by family history researchers as a method for preserving a tombstone’s inscription. Learn how to do a grave rubbing safely, and when to use an alternative method of cemetery documentation.

How to Do a Tombstone Rubbing
1. Get permission. Check with the cemetery or with the state or local historical society to learn if tombstone rubbings are permissible. This practice has been banned in some areas and cemetery locations due to the damage it can cause.

2. Be sure that the tombstone that you have chosen is sturdy and stable. Do NOT do a tombstone rubbing on any stone that is wobbly, flaking, chipping, crumbling or otherwise unstable. Take a photograph instead.

3. If allowed, clean the tombstone with plain water and a soft bristle (natural or nylon) brush. Scrub the stone from the bottom up to avoid further streaking and staining. Flush well with water when you are done. Again, do not do this on a stone that is crumbling, chipping or flaking.

4. Cut a piece of plain white paper, butcher paper, rice paper or Pellon interfacing material to a size slightly larger than the tombstone. You can obtain rice paper from art supply stores and Pellon from craft and fabric shops.

5. Tape the paper or fabric to the gravestone. Make sure that it is secure so that it won’t slide as you are rubbing and cause a blurred image, and that it covers the face of the stone completely, so that you won’t get marks on the tombstone when rubbing. If you have someone with you to assist, then you may prefer to have them hold the paper to avoid any possible damage from using tape.

6. Using rubbing wax, a large crayon, charcoal, or chalk, gently start to rub along the outside edges of your paper or material, carefully working your way in. Or you may choose to begin at the top and work your way down the tombstone.

7. Rub lightly to start with, and then apply more pressure to darken in the design if it suits you. Be very careful and gentle so as not to damage the tombstone.

8. If you used chalk for your grave rubbing, then carefully spray the paper with a chalk spray such as Krylon. Hairspray is another alternative. Be very careful not to get any on the tombstone.

9. When the rubbing is done, carefully remove it from the tombstone and trim the edges to suit your liking.

10. If you used interfacing for your tombstone rubbing, then place the material face up on an ironing board with an old towel over it. Press down with a hot iron (don’t use a back-and-forth motion) to permanently set the wax into the fabric.

http://www.genealogy.about.com

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s